remove

Today I fitted the genuine Yamaha tail tidy part number. BS2-F16E0-00 The instructions where good for the easy parts but could have done with a few words in places. I started buy building it first to make sure it all looked right. After I was happy I started to remove the parts from the bike...

Hi everyone. Today i had change the new spark plug ( NGK CR9EIX iridium) for my 2015 MT09. I run a stock exhaust and stock air filter but i will get the akra full next month. So i remove the AIS and block the plate. After everything changing and remove, i put the tank on and the bike is so hard...

Bit of advise needed guys I've got a mivv oval carbon fitted with a dna filter I'm thinking of removing the baffle....will it be ok to just remove or will I need to have a remap on my ecu doing too.

Hi All I tried to reach the 12V power outlet and tried to take away the fuel tank covers but failed. Below are my steps 1. take away passenger seat 2. 2 screws to take away driver seat, I see battery and fuses. 3. 1 screw to remove the black rectangular rubber strip on the tank. 4. the...

Have you ever been told to remove your crash helmet at a petrol station before they will start the pump? If they ask you I wonder would they then ask you to remove this?

Eyup chaps, I would very much appreciate any guidance from you on how to go about removing the ECU on the Tracer, as I'm planning a re-flash (By Simon @ S-Tech) and need to remove the ECU to post it off. I've done various searches on this forum and the T'Interweb but not found owt as yet. I'm...

I have the Australian restricted model MT07. I reflashed the ECU and have Akra snail pipe and DNA filter and the throttle rotation restrictor was removed, but the dyno run revealed sill only 54rear wheel HP. Now the reflash was to Euro spec so the only difference should be the 655ccrelarive to...

I have a Monokey V47 topcase and M5 fitting plate which, apparently according to Givi, will fit my MT09. The fixing kit will require drilling some holes in the MT plastic surround....has anyone tried this, and how did you fare? Better still, any pictures of how to remove the plastic bits from...

hi all , has anybody got a good cleaning tip for the akrapovic downpipes , I've got some tar like deposits that are really hard to remove , tried wd 40 but the spots won't budge . cheers everyone

Could anybody tell me why Yamaha chose to restrict the revs in the top 2 gears and why you aren't told about it before you buy.Is there an affordable solution or can you ask Yamaha to remove them.

well today I collected my new mt09 and loved the ride home after a year without a bike was heven. decided to buy last week and fit today an r & g radgaurd. I have one question and that is where does the little plastic spacer fit ? do I remove the metal spacer and insert the plastic one in its...

hi all , anybody using the abba superbike stand ? used one on the MT 07 but had to take side plates off first , just wondering if you need to remove anything off the MT 09 too , cheers

I've been looking around for how to remove the restrictions on the MT07, and to my understanding there should only be a throttle restriction on the EU versions? I dont really understand how to remove it. I believe its the bracket over the throttle pulley with the finger that goes down and...

Having recently scrapped off clumps of salt from the centre downpipe from where road surface water gets sprayed there by the front tyre I had a look up under the radiator and was surprised to se how much filth had gathered. Purely as a preventative measure, this morning I decided to remove the...

I'm looking around and i'm not finding where i can remove my profile. Does anyone have a clue?