Ok, so I've been a little busy.
Got the ermax undertray, tail tidy and front and rear Yamaha LED indicators installed.
The tail tidy went in quite easily, found the wires in the LED license plate light a little thin, but being an electrical engineer I got it done. I did disassemble far more than I needed too, like the side panels etc. and the Norwegian plate is a bit big, so there is not much room for the indicators, it turned out ok, but I was considering getting some 10mm spacers for a while.
Yamaha LED indicators, not sure what to say here, granted I think they look great, but...... And there is a huge BUT..... The installation was way to complicated for a oem part.
Why on earth don't Yamaha supply these with the same plug as on the bike? I bought an oem part, I should NOT need to cut off the plugs from the indicators I removed, and spice wires.
I expect to get a bolt on, plug and play part when I order oem modification parts, the only thing different from an eBay set is the design, and the silly price tag.
Not good Yamaha, not good at all.
The bike looks great though.
As for the hugger, I decided to wait a few days with this, I'm bringing it with me to a vinyl shop to see if I can colour match it to a wrap.
View attachment 1946
View attachment 1947
View attachment 1948
