Search results

I have been running these on my bike for the past few months with no problems. 4X 5 LED Motorcycle Bike Turn Signal Indicator Light Universal 12V Metal Casing | eBay I also replaced my indicator relay with a LED Electronic one & run no load resistors. I also made up my own tear drop blanking...

Thanks for your feedback guys, there is no need to remove the tank, just raise it up & prop it up with a block of wood just enough so you can get your hand under the tank to feed the O2 controller loom through.

Photos to come

Air box mod results here: http://mt09.motorcycle-talk.com/forum/mt-09-modifications/2321-kevs-mod-6.html

photo's to come

Sweet, weld done mate

Stay away from the cheap ones on EBay they are no good, been there done that I have a few 320mm wavey paper weights.

Photos to come

I like the look of that, I want my dash behind the Yamaha OEM screen that mod plate should do the trick, just ordered on, I will post up some photo's when it arrives.

That looks trick.

Welcome mate these 09's are great bikes.

Thanks for your feedback mate. Don't forget guys this is the only MT/FZ 09 forum where you can buy this mod with a discount just for being a member here, all orders via PM to claim your discount, I will need a country to where I am posting so I can get the postage cost right & an email address...

In the testing we did with the O2 sensor disconnected the closed loop ran around 14:1 & after a few mins or riding in the closed loop it starts to cycle the A/F ratio & would end up at times as rich as 12:1 in the closed loop & the bike starts to splutter a bit between open & closed loop...

Yes Dyno Jet's O2 Optimizer & my O2 controller both work on the same principle, Dyno Jet's answer to the closed loop mapping is their O2 Optimizer which is supplied with all PCV's for the MT/FZ09 which works far better than not having one, I tested their O2 Optimizer & the closed loop A/F ratio...

Good to meet you today Rick nice to meet guys with simular interests, you came a long way just to have the O2 controller fitted, Rick has a Dyno built custom PCV map with one of Dyno Jets O2 optimizers + Akra titanium pipe + BMC filter, today we removed Dyno Jets O2 Optimizer & replaced it with...

The O2 controller will work with any map loaded, as none one has correct the A/F ratio tables in the closed for any map.

Looks like Santa has arrived late.

The re-flashed 2014 OEM map open loop A/F ratio is between 13:1 & 13.6:1 across the whole fuel map, with a custom map you can set the A/F ratio anywhere you want it in the open loop.

Photos to come

Read my EBay rider feedback for further feedback, I have said this a few time to you now not sure what else I can say, there are improvements over any map installed in the ECU because no one has altered anything in the closed loop mapping, there are improvements over the Flash Tune maps, STD...