connector

Hi All Does anyone here know where I might be able to get a replacement connector plug for the tilt/cut out sensor, as I have had a little mouse issue and he decided to eat some of my wires. It is the white plastic piece in the photo, from Yamaha it is all part of the main loom, my local...

Ok guys. Ignore the hand pointing. I am too lazy to take a photo. I need help here. What is this white connector for? The one pointed by the red arrow. It has 4 leads is there any chance I can use the red one for IGN live signal for a relay?

I recently bought a Abus Sledg 77 padlock along with a specific holder for carriing it. But I was afraid of not remember to removal the padlock and going ground :( With the padlock came an spiral cable for attaching it from the padlock to the handlebar, but it seemed very inconvenient so I...

Is anyone have any issues with this point.? You know the one under the side cover left side of the tank..?? Because so far ive gone through... 1 USB connector & 1 SAT NAV holder.. Im starting think it maybe causing something?

Guys Do you know where to purchase the connector for the auxiliary 2A fused power supply in the UK? I understand that the connector just has a blanking plug fitted as standard. Many thanks

Does anyone know the make, model, or type of the auxiliary power connector under the tank I will be needing to connect to it but would prefer to use the proper plug rather than cut the loom.

I am looking ahead to fitting a Scorpion exhaust.I will need to remove the Lambda and to avoid twisting the 4 wires when unscrew from exhaust I reckon I need to separate the connector block which is behind the trim plate.The "block" appears to have 3 "nibs" which lock the 2 halves together,if I...

Hi Everyone, I have been around the houses trying to find the correct DC connector for the MT09 and have finally done it... First, RTFM (Read the manual) the DC connector is behind the Right hand panel and NOT the left as you sit on the bike. Also, many posts will refer you to this site...

I want to wire my sat nav to the spare connector for the additional 12 volt accessories socket, I took the fairing parts off and found two blanked off connectors next to the existing 12 volt socket connection, is one of these blanked connectors meant for the additional 12 volt socket, thanks in...

Hi guys So I bought a GPS for the bike, and wants to use the DC Connector located on the left on the bike, as shown below. I want to purchase a connector to connect to the GPS' wires, but I can't seem to find any. Can anyone help?

I am trying to find out where the diagnostic connector for the FI system is located, I have a universal CAN BUS reader and want to try and hack into my ecu. any one have any idea and what protocol is used, I have acess to J1587 and J1939 as well as ISO OBDII readers.