• Welcome to the Yamaha MT-09 / FZ-09 Forums. Member registration disables ads and allows you to post and share. Register Here.

Connecting Scottoiler


Use the same connection on the throttle body's used for
the throttle body sync, some bike don't have a pipe on the
right side so connect to that if it as a pipe both sides use
a T piece, you can get them for air pipes used on fish tanks.
 
Yes but check the one on the other side as it may just have a cap on it so you wont need a T piece.
 
Yes yours must not have the air box flap some don't so yes connect it to that.
 
What is the air box flap?

The pictures is from google, in my MT the left side is connected to the air box or the fuel tank, and the right side go into a small white round plastic which I do not know what he was doing.
 
If it's there it shuts a flap at certain revs and throttle openings to
pass noise tests yours wont have the silver round vacuum actuator
on the air box and the snorkel will point back instead of forward.

 

Attachments

  • 20150725_175203.webp
    20150725_175203.webp
    53.5 KB · Views: 629
  • 20150725_175248.webp
    20150725_175248.webp
    53.1 KB · Views: 585
  • 20150725_175258.webp
    20150725_175258.webp
    41.4 KB · Views: 588
  • 20150725_175528.webp
    20150725_175528.webp
    43.3 KB · Views: 1,161
No that only as vacuum at certain times you need to tee into one of the first two.
I thought the pic with the rubber cap instead of the pipe was your bike as I said some
are different .

Get a T connector if there's not one in the kit,
Pull the pipe off and connect it to one end of the T
Run a short pipe from the T to the org connection on the bike.
Connect the Scot oiler to the other connection on the T
using a short bit on new pipe saves cutting the org one.
 
bae684fbd7738e2c1b62874f20196388.jpg
 
You must log in or register to reply here.


Back
Top